Dump

The waste regulation was disciplined by DPR n.915 of 10/09/1982. The DPR n.915 disciplined the waste disposal and introduced several principles on the definition of systems that tend to limit the waste production, it divided waste in urban, special, toxic and harmful waste. On February 1997 the DPR 915 has been superseded by the Decree Law n.22 (decreto Ronchi), that focused the attention on the prevention and the waste quantity and hazardous reduction. With the Landfill directive 1999/31/CE and the transposition National regulation (D.Lgs 36/2003) has been reached a “best practices” referred to both construction, management and post-management technical regulation of plants, and to waste barrier entry. With the following of the Decree of August 3, 2005 “Definizione dei criteri di ammissibilità dei rifiuti in discarica” the legislator has defined the operating procedures, that are the waste selection criteria and procedures in landfills, in accordance with the D.Lgs. 36/2003. In April 2006 entered into force the D.Lgs n.152 ( called “ testo unico ambientale”) that deeply modified the regulation introducing a wide range of innovation of the regulation on environmental impact assessment and the strategic environmental assessment, on the soil protection, the safeguarding water resources against pollution and the water resource management, the waste treatment and disposal, the recovery of the contaminated sites and the pollution. With the D. Lgs n.205 of December 3th 2010 the legislator adopted the EU guidelines concerning the policies to adopt on waste disposal, defining the waste management priorities based on the best environmental option in planning policies. Consequently the waste disposal in landfill is the final level in the integrated circle hierarchy of waste management, and plays a role increasingly residual. The landfill is a system which starts a disposal of few typology of waste, at the solid and muddy state, both urban and special. The regulation described above consider 3 typologies of landfill:
- •For inert waste.
- •For not dangerous waste (urban and special waste not dangerous).
- •For dangerous waste ( waste mainly with industrial and production origin).
The system consist of the final disposal of waste in a configured site, in which are placed and compacted on overlapping layers for a better exploitation of surfaces. At the end of every day waste is covered with different types of material, e.g.: membranes in geotextile fabric or cloth in carbon foam, excavation soil or other inert material, fixed organic fraction (biofixed or off specification compost), from the processing of urban waste. Depending on geomorphological and hydrogeological characteristics of the site, there are 3 types of landfill::
- •In a depression: made to fill old dismissed quarries or trenches specifically dug on the ground.
- •Elevated: placed on ground level and with development in height.
- •In the surroundings slopes: fill areas with high differences, appropriate for the presence of quarries or natural depressions.
To contain the entire mass of waste and to prevent the loss and diffusion of the perculation in the environment and on the ground, are built protective barriers on the bottom and on the sides of the landfill, naturally (clay) and/or artificially made (polyethylene sheets).The dump is without doubt the form of disposal with a higher impact and less “productive”. However, even from this process it is possible to extract value, in the way of landfill gas. During the decomposition of waste, beyond the production of drained perculation and sent for the treatment in a sewage plant, biogas is produced. It is mainly made of methane and carbon dioxide, it is extracted with a pipe system located in the waste interlayers and conducted in suitable generators to produce electricity. This operation also contributes to avoid the diffusion of a bad smell in the air and allows to decrease the methane emissions (greenhouse gas 20 times more powerful than CO2) in the atmosphere, reducing the greenhouse effect in accordance with the principles of Kyoto Protocol. Moreover its use for the production of electricity consists in avoiding the CO2 emission produced by combustion from conventional fossil sources, as petrol and coal, obtaining a double positive effect: On one hand the reduction of greenhouse gas emissions occurs on the other the increase of production of electricity from renewable sources. In 2014 from the biogas recovery almost 60 GWh of electricity was produced, the same amount that 19.500 families would use and was avoided the emission in atmosphere of 28.000 tons of CO2. Other than what was already described, in terms of emissions control and environmental impacts, checks on chimney electricity product engines, water discharges, waste, ground and subsoil and air quality in frequencies defined in the integral environmental authorization, through certified laboratories, are annually done.